MICACEO is an exterior protective enamel, based on lamellar micaceour fillers and iron oxides. Anticorrosion agents improve MICACEO resistance to rust aggression while lamellar fillers protect the iron surface from atmospheric agents deteriorating actions. MICACEO, applied on iron supports, gives to the surface an old-like appearance, granting high rust protection and resistance to ultraviolet rays and saline fog. Due to its high tixotropicity, MICACEO can be applied in double thickness than usual enamels, without dripping.
SURFACE PREPARATION
New iron or steel surface: clean carefully from all grease or oil or rust , apply one coat of primer (NOXIDE).
Old iron surfaces: remove all loose and flaking paints by iron brush, eliminate all rust particles. At this stage a chemical rust converter (NO RUST), can be applied on rust areas, to stop the aggression; otherwise, use a coat of NOXIDE.
APPLICATION:
Dilution: max 10% white spirit.
- By spray gun : (nozzle 2,5 mm) apply two coats of MICACEO
- By brush: latest pass of brush should be light and vertical, to keep surface as even as possible.
Important: do not apply under rain or when the air temperature is lower than 10° C.
Drying Time: 2 hour touch dry. Completely dry after 24 hours.
Consumption: from 6 to 8 m 2/lt according to substrate absorption and dilution.