Description
Blued antioxidant enamel finish (fine-grained) applied directly on iron oxide. Anticorrosive pigments with zinc and particulate micaceous iron high lamellarity, provides excellent protection against oxidation.
Main Properties
- Excellent protection against corrosion Soft touch and easy to clean
- Excellent adhesion
- No cracks
- Thanks to its formulation with alkyd resins, it is very brocheable and easy to apply.
- Its drying time allows the product to be worked without any touch-ups being noticed.
- Long-lasting finish resistant to UV rays.
CERTIFICATIONS
- Certification Euroclasses of reaction to the fire in category B s1 d0
- UNE 48316: 2014 High performance anticorrosive decorative enamels (certificate available from 1/4/2016)
- UNE 12944-6: 1999 Protection of steel structures from corrosion to grade C4 Media (certificate available from 01/04/2016)
- UNE 9227: 2007. Salt spray test than 100 microns (certificate available from 04/01/2016)
- UNE 6272-1, 1520 and 1519: Impact resistance, flexibility and drawing
APPLICATIONS
For doors, lampposts, fences, railings, furniture, steel structures, machinery and iron anything outside or inside.
Appearance: Bluing (fine-grained)
Yield: 10 to 12 m² / Lt (approximate and as support).
Drying (by color, thickness applied and room temperature)
- Total: 3-4 hours /
- Repainting: 18-24 hours.
Number of layers:
In metal previously painted and in good condition, apply 1 hand. If it is discovered or rusty, apply two coats. On metal subject to extreme conditions, we recommend previously applied primer Antioxidant Tollens solvent (art.8700). Cover corners and edges well. In areas of welds apply three coats.
Application tools: Airbrush, roller or spray gun / air-less.
Cleaning Solvent
PREPARING THE SURFACE
The surfaces should be clean, dry and free from grease, dust and loose rust.
- New iron and steel surfaces: Remove loose rust with wire brush and degreased.
- Painted surfaces: If the paint is in good condition, wash and proceed to a light sanding. If it is not properly attached, remove paint with sandpaper and clean up the resulting powder. always remove loose rust with wire brush.
- On galvanized, copper, aluminum and other non ferrous metals: Sanding to refine and apply a coat of primer on Galvanized Tollens solvent (art 8701.). For all other surfaces, consult the technical department of Cromology