Description
Polyurethane special effect lacquer. Based on high solids technology. Easy to apply. High covering. Smooth, hard, tough and silky finish. Colour, graining and look of natural wood. Wash resistant. Intermixable weathering-resistant colours.
Fields of Application
For indoor and outdoor use. Special for imitating wood with a single coat. On any non-porous or enamelled surface: doors, frames, cupboards, household appliances, panelling, windows, etc..
GENERAL REMARKS:
Stir well before using. The surfaces to be painted have to be clean, dry and suitably primed. Remove all existing rests of dirt, grease, poorly adhered rust and previous coatings by using thinner or paint stripper, depending on requirements. If possible, remove the objects that may interfere with the path of the brush: such as locks, handles, peepholes and sundry embellishers. Apply in plentiful even coats. Finish with long strokes in the direction of the grain. Straightaway and up to ten minutes after application, highlight the grains, depending on requirements by gently passing the tip of the dripped brush in continuous, parallel or wavy lines in the same direction. You will get more marked grains with uneven tip brushes. Do joints by areas and parallel to the grains.
BARE SURFACES:
- Wood: Sand wood following the wood grain, thoroughly clean, remove all resins or resin secretion on the surface and smooth up sharp edges. Apply Protector, Sealing-Primer or Multi-Purpose Primer depending on requirements.
- Iron: Synthetic Rust-Preventive Primer or Multi-Purpose Primer. For outdoor surfaces, at least two coats of the selected primer will be needed. For indoor surfaces, one coat will be enough.
Melamine stratified resin board: Degrease and sand to matt.
Other surfaces: Please consult your dealer.
In all cases for:
- Indoor surfaces: One single coat of TITANLAK Wood Effect is enough on most surfaces.
- Outdoor surfaces: For achieving a better resistance to weathering, apply at least two coats of TITANLAK Wood Effect.
Coverage: 10 - 12 m2/l
Drying: 6 - 8 hours
Recoat time : 24 hours
Methods of Application Flat brush
Equipment Cleaning Odourless Thinner or White Spirit